Bersa Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi everyone, I purchased my Bersa about a month ago. I love this gun and plan on it being my EDC. I just purchased a Foxx hybrid for concealment. When I was cleaning my gun the other day I noticed that the front sight on my gun shifted. I inspected and it is loose and will easily move back and forth but not come completely out. At least I didn't push it hard enough to remove it. I have heard that you can put some red loctite under the site to shore it up. Is this the correct move or should I send it back to Bersa?

Sent from my Slider SL101 using Bersa Forum mobile app
 

·
Premium Member
Joined
·
5,515 Posts
It would probably work. I use slow set epoxy on some of the guns with loose sights that are suppose to be Set in. Gives me a little work time, like 30 minute set. The 5 minute set time is just too quick for that kinda work.'

However, most of the guns I have are used. So, I have to fix them or pay for a fix. Couldn't advise you to do this to a new gun with a warranty. Might void your warrnanty.
 
1 - 2 of 2 Posts
Top