Bersa Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 · (Edited)
My BT-22 will slam forward when inserting mag occassionally so I compared the spring tension on the slide release to one of my 380 BTs and there is a difference in tension. Based on this I would like to change out the spring on the 22. Can anyone give me a hint as how to start and is this considered a difficult task? Thanks in advance.

Note: Later this morning after I posted this I found a viedo on youtube that makes sense of this subject and expoains it rather well.
 
1 - 1 of 1 Posts
Top